Thank you roj leather and Simon for your recommendations. I like the hanging chair and the almanda creeper on the wall. This will certainly liven up the patio.

OK... but the wire wont be lower as it is fixed now. The wire in the pics below is the wall facing each other. They were leveled on equal height but the beam on one wall makes it seem a little above. But i think you guys are absolutely right that up and down lights wont look good there. I think you are right about down lights lessismoore. Would it look good if i go with two different lights on opposite walls??? it would look odd right.

Hi Cornerstone, I read your feedback 1. Profile handles I was late as the doors were already ready and it was too much of re-work. Regarding putting handles 2. Sharp edge can cause problem thats why the handles I have put are rounded on the edge not to hurt. 3. Where I did make a mistake was Did not put fillers. If I had put fillers on the sides the door issues could be resolved The upper cabinet handles. This is actually not my fault I had told them to put the handles in the center but they thought these are not drawers but rather cabinets so they should be put in the location where we put the vertical handles. By the time I came to check it was too late and now I am stuck. I am thinking of putting maybe 8inch handles instead of current 5inch but not sure if that would help to improve the look. Old kitchen pictures attached they also had handles but smaller

Thanks. Somehow I did not have luck finding good carpenters, Here is how I wanted the drawers to look. Here is how carpenter from my locality (not too cheap a neighborhood, called Lokhandwala) tried to make, A you can see, he tried to chisel the wood to get this design. Obviously had no clue. Finally he gave up, Brought the unfinished desk in with an excuse to show me how it is coming along, left it with me and never showed his face again. So I tried an expensive carpenter, who did some work at an apartment on NapeanSea Road, a very expensive locality and paid him what he wanted. He too did not know how to make this. All he did was out a moulding in the center to make it look .as though it were similar to what I wanted. At least his work was clean, except that he represented that the top was teakwood while I lter found out that it is mango wood, but he too did not know how to get this done. I hope one of you can suggest a carpenter with some skill.