How do you decorate your place, what kind of style, colors, and feelings? That will greatly influence the type of door you might want. Also, think of your budget, and whether you want to install it yourself or hire a professional (you don't need to tell us, just keep that in mind). Then look around Houzz, in the products page, they have lots of interior sliding doors and hinged ones, from elegant frosted glass in a dark wood frame, to rustic reclaimed wood planks. You may not want to purchase that exact model, but it might give you a better idea of what would fulfill your airflow needs without sacrificing style.

Mohammad. I understand your program. You may be lost in the details at the moment. Please do follow and trust the advice given here by all these people. You are about to embark on a reasonably expensive journey. Get professional help with someone who you can sit down at a table and brainstorm with them your ideas and intentions. There are Architects and there are professional building designers who are members of the American Institute of Building Design (AIBD) who are well versed in projects such as yours. I personally love a design challenge. After 38 years designing homes and special use buildings I enjoy this type of challenge the most. I am in Ohio and may not be close to where you are but I am sure with a little investigation you will find the best design professional for you.

1.Remove Door and Trim If you're adjusting an existing door frame in your house, first, you will have to remove the door itself and all of the trim surrounding the frame. The door is simple enough; just pull the hinge pins out of place, tapping them from beneath with a screwdriver and mallet if necessary. For the trim, wedge a flat pry bar underneath the edge on one end of a section, and gently pull the casing away from the wall. Do the same thing for all of the pieces around the door frame and carefully set them aside to reuse later. 2.Square the Opening Off It is difficult to ensure that a door will be level and square if the rough opening is not (the rough opening is the bare bones structure before any work is done to begin a door install). So, before you begin, use a carpenter’s square to check the upper corners. This will save you time and effort later on. Remember, the more accurate your measurements, the more level your door will be. 3.Shim Door Frame Placing a pre-hung door in the rough opening will give you an idea of how it will ultimately fit. This type comes complete with a pre-made frame surrounding it, so all you need to do is carefully slide it into place and shim wherever you need around the frame to level it in the opening. Remember that wooden shims can simply be made of wedges or blocks of wood. Place a level against the door frame in your existing installation to see where you need adjustments. Then, like before, place wooden shims until it sits as it's supposed to. To keep the shims in place, nail them to the hinge. Make sure you trim any excess pieces with a saw so they sit flush with the wall. 4.Get a Level Sill Next, adjust the door sill with a flat bar or wedge until it too is level. Place the wedge or bar under the latching side of the door frame and have your help hold your door so you can check to make sure whether the top of the frame, or lintel, will need more adjustment. 5.Double Check It is important in every project to double check your work. Take the time to measure the gap between the door frame and the original rough opening. Use and nail in more wedges where necessary. If you have the extra set of hands to spare, have someone re-measure if you feel it could be adjusted differently. 6.Secure Door Frame in Opening Place your blocks of wood and/or shims into the open space over the lintel, and begin attaching the door frame to the original rough opening. Again, double check each corner to be square, before completely securing it into place. Note: Do not worry about the finishing touches just yet. You can add framing to the door after applying the paneling or drywall. Also, head and side casings will finish off a new installation nicely, covering all your small shim adjustments. Thanks & Regards, Cathrinfrancis URBELITE Bangalore

Hi Farooq, you should go for wall paneling on that wall with a concealed door. The wardrobe can be a part of the unit in front.