I strongly second One Plan's idea about looking for another architect. If this one is not motivated, all the fame in the world is not going to help. An alternative approach to finding an architect is to find some good contractors who have built things you like. Ask them for architects' names. Make sure they work in your price range. In the meantime, you can find out from your local building department what the set back and height restrictions are. Are you required to build parking areas or garage space, what kind of airspace restrictions do you have for neighbors' views and sunlight, that kind of thing. Often this stuff is on city websites or handouts at the office.

It's a bit hard to tell, it looks like some of the proportions are not correct. Given what you have drawn it looks like entering and exiting your shower is going to be awkward. I'm not certain that you'll be able to open the door all the way because of the placement of the tub and vanity. Here are a few suggestions: Ditch the corner tub, and use a rectangular one that is installed with the long end on the wall opposite the vanity and shower and install the toilet next to the tub. Slide the door to the right, and you'll be able to have a larger vanity and/or shower. If you can use a pocket door or something of the like you'll gain wall space like sandpat mentioned. I don't see any storage planned. Have you thought about where you'll keep towels, toiletries, etc-?

First of all the images you posted you cant make anything out what you got there. Secondly you should contact a local Architect when doing something like this, not only for structural reasons, but window design as well. He will layout window detail based on the window sizes available from a certain manufacturer or you can take his drawings which indicate opening detail to a place who sells windows, and they have catalogs of window combinations and sizes to make it work with what you have.

Hi Cornerstone, I read your feedback 1. Profile handles I was late as the doors were already ready and it was too much of re-work. Regarding putting handles 2. Sharp edge can cause problem thats why the handles I have put are rounded on the edge not to hurt. 3. Where I did make a mistake was Did not put fillers. If I had put fillers on the sides the door issues could be resolved The upper cabinet handles. This is actually not my fault I had told them to put the handles in the center but they thought these are not drawers but rather cabinets so they should be put in the location where we put the vertical handles. By the time I came to check it was too late and now I am stuck. I am thinking of putting maybe 8inch handles instead of current 5inch but not sure if that would help to improve the look. Old kitchen pictures attached they also had handles but smaller