There is contrast between the traditional furniture and the focal point of the floor which pops, draws attention. I would recover the sofas in cream colored soft fabric - suede. I would leave the curtains grey, and put down a large neutral area rug. The edges of the room would show the pattern of the floor. I would color the wall and add texture to it, but not too dark as the room will appear smaller. Add a picture and put a nice plant holder, large vase in the left corner of the room - an oriental-style vase. Or, a cream-stripe fabric on the sofas. You could go soft or bold in this room - depending on your taste.

OK... but the wire wont be lower as it is fixed now. The wire in the pics below is the wall facing each other. They were leveled on equal height but the beam on one wall makes it seem a little above. But i think you guys are absolutely right that up and down lights wont look good there. I think you are right about down lights lessismoore. Would it look good if i go with two different lights on opposite walls??? it would look odd right.

Unfortunately all your options require custom work: It looks like you need an 18" corner cabinet. You will have to modify the last wall cabinet on the left. As I am eyeballing it, you should be able to cut the last cabinet in the middle and then shorten the left section to fit the space of the wall next to the door trim. It's an option that makes the area looks symmetric. Or you can install shelves over the sink. I would not recommend it because it will take the looks away. And the last option will be to remove the last cabinet, shorten it so it fits over the sink and install a single cabinet where the double one was. This will leave a triangle space behind the corner where the two cabinets will meet. You can block the space under it. Hope this helps!

A good tile installer that knows what he is doing, can easily remove that single piece of tile.... carefully replace it with another one. Do you have another extra pieces of the same tile? Do you know what brand and color the existing grout is? That will be more of the issue trying to get the grout match to match up or the finding the same tile (in the same dye lot) if you need to buy another tile. Did the heat cause the break or did a pan bang into the glass? Consider installing a heat resistant Lumicor or 3 Form panel behind the stove. Any flat material that can be sandwiched between two resin panels. 1). Crushed glass. 2). Fabric. 3). Fabric. 4). Fabric.