Hi Cornerstone, I read your feedback 1. Profile handles I was late as the doors were already ready and it was too much of re-work. Regarding putting handles 2. Sharp edge can cause problem thats why the handles I have put are rounded on the edge not to hurt. 3. Where I did make a mistake was Did not put fillers. If I had put fillers on the sides the door issues could be resolved The upper cabinet handles. This is actually not my fault I had told them to put the handles in the center but they thought these are not drawers but rather cabinets so they should be put in the location where we put the vertical handles. By the time I came to check it was too late and now I am stuck. I am thinking of putting maybe 8inch handles instead of current 5inch but not sure if that would help to improve the look. Old kitchen pictures attached they also had handles but smaller

Hi Nitin, Thanks for the valuable suggestion, but can you have some brief on why BWP ply-boar and why not BWR, majorly what is the difference amongst them, And you are telling for lamination, lamination of what (pvc lamination you are talking about) or some other, if pvc lamination then i heard and googled that pvc lamination color will get dull after some time and scratches can occur, whether we are having other lamination options which can resist long period of time. please majorly not consider price as blocker, i am going to Reno after 20 years so it would be the best from my side, please suggest consider durability, no dullness in color, and with strong panels. Thanks

that is what i have added if you can see the pic above.. want some suggestions on partition that i can use between dining and sitting

Please Read, 1) Following are the photos of my Mumbai apartment (10th floor) kitchen. Water heater and water purifier were already (haphazardly) installed by my contractor before I came to occupy the apartment. Answer : u can shift the purifier above sink , inside the cabinet which will be made by carpenter. 2) We now have to install cabinets above the counter. ( you can ) no problem. 3) I want to get the PNG gas pipes installed to replace the existing cylinders. Answer : This work you can do after carpentry work. 4) When I saw other homes it appears I not only need pipes but some ghastly looking meters/ valves etc. Answer : meter will be hidden inside above cabinet toward right side and pipes will be inside the hob side counter will transfer through the balcony wall to meter again. 1) The gas pipes will come from the wall next to the balcony doors. The sink is just next to this wall. Will it be possible to install the pipes and meters below the cooking counter or is that not practical? - - Don't know what are all the practical considerations. Safety, access to meter to take readings, location of the sink? ). everything is possible.. 2) If under the counter installation is not practical, where should the pipes and other boxes/meters go? as mentioned above.. 3) Is there any practical solution to clean up the wall with water purifier and heater? (please note the kitchen has a 6" thick beam on the top of the wall above the counter, also 6" think pillars one in the corner and the other large one near the microwave as shown. Additionally it has a protrusion on the ceiling, probably this houses the drain for the apartment above me. ( for above apartment kitchen nahani trap chamber it is... )