OK... but the wire wont be lower as it is fixed now. The wire in the pics below is the wall facing each other. They were leveled on equal height but the beam on one wall makes it seem a little above. But i think you guys are absolutely right that up and down lights wont look good there. I think you are right about down lights lessismoore. Would it look good if i go with two different lights on opposite walls??? it would look odd right.

Tsilanko, I would always recommend professional installation where needed. But what I am doing here is suggesting that WHEN you are planning to build or renovate, to consider how your plans will affect you in 20 or 30 years time. Split levels are very hep when you are young. A kitchen 3 steps down at 30 is rarely a problem, but might be a hazard at 60, or, as Marjie1059 suggested, if you break a leg. ... All my parents' homes were terrible for old people. They were forced to move to a bungalow in extreme old sge because the location and design of their home was more suitable for an active young couple with a large family than for an elderly couple with stroke disabilities. I would not want to move again, so my present home has features built in that make ageing in place simpler. Mostly small changes, like grab rails, and lever handles on doors and faucets. A major disability suddenly suffered requires major changes if permanent. I did look at this because it came up in the discussion, but if you look at the heading, Planning for Disability, it means just that. Plan ahead so you don't have to make expensive changes later on. But thank you for your advice, yes, major changes are not in the DIY domain.

Hi Cornerstone, I read your feedback 1. Profile handles I was late as the doors were already ready and it was too much of re-work. Regarding putting handles 2. Sharp edge can cause problem thats why the handles I have put are rounded on the edge not to hurt. 3. Where I did make a mistake was Did not put fillers. If I had put fillers on the sides the door issues could be resolved The upper cabinet handles. This is actually not my fault I had told them to put the handles in the center but they thought these are not drawers but rather cabinets so they should be put in the location where we put the vertical handles. By the time I came to check it was too late and now I am stuck. I am thinking of putting maybe 8inch handles instead of current 5inch but not sure if that would help to improve the look. Old kitchen pictures attached they also had handles but smaller

Hi. I hope the counter is thick enough to take the weight of the sink and water. atleast 25mm to drill in the undermount sink clips. Drill clips are available easy, you can look up Blanco and Franke EL undermount clips. If the counter is thin, you risk cracking while drilling, in which case it is better to use epoxy sink clips. A brand you can find in India is Solartime. They are expensive but you can get your local fabricator to make you a dozen clips and get them galvanised to prevent rusting. Do remember to apply silicone sealant between the undermount sink and the quartz generously. I know how you feel, things that are easily done in the west can be a pain to achieve in our country, especially places other than major cities.