I suggest you follow the step-by-step guide for creating storage cabinets under the bathroom sink. Take proper measurements - Measure the available available space in height, width and height. Cut Plywood to size - With a circular saw and framing square, cut all the required pieces out. You can use a sliding compound saw as an alternative. Attach the base and sides - Start assembling the sink cabinets by placing the bottom piece of plywood sheet on a flat surface. Attach the back and top boards - Place the plywood sheet for the top part of the cabinet and attach wood screws to connect it to both the sides. Turn the back faces of the cabinet upwards. Keep the back piece over the structure and fix it into place with wood screws. Attach shelves - Place the cabinet in an upright position to install the shelves. Slide a shelf into the structure so it is flush against the back. Attach door - Keep both hinges of the door on the same side of the plywood sheet. Drill them using wood screws into place. Now keep the door over the cabinet structure, extend the hinges to one of the side panels and fix them to make them secure. Fix a hasp closure on the other side of the door, placing it in the center of the hinges.

Hi! Yeah it will. You will have to get your plumbing lines capped and replaced. It's not advisable to have a joint in the plumbing line. So the one that you are wanting to pull to the new sink will need a fresh line put in from the last bend it has. I hope that makes sense! Best! Miloni

the sink should be at 33" from the floor. your countertop height will depend on if you're using a top mounted or insert sink

I have the same kind of bathroom and saw the same video. I used an angle grinder to remove one of the walls. You have to have hearing, breathing, and eye protection. I don't think there is any way to avoid the dust. I'm going to direct a fan to an open window in the bathroom. My sinks are top mount so there was no problem removing it. I replaced the faucet only for now. I also changed out the drain and stopper. The old one was rusted to the sink. I had to bang on it with my loader from my tractor with the sink upside down to get it off, lol. I have put off removing the rest of the wall and the cabinet because it is such an ordeal. You might check with Daltile to see if they still make the tile. Maybe try cutting away the cabinet while keeping the counterop supported and then dropping it so that the joint gets more exposed? I'll be interested to know if you get to this before me but I'm doing an entire gut job.