I like this tile as well. Very sleek and mod looking. I would consider running it vertically instead of the picture horizontal pattern. It might give the illusion of more height in the shower surround. The color is great. If you are worried about it being "too much," you could always see if they have the same tile in a different shade and mix the two or doing one wall in a contrasting (lighter) color. I personally like it as long as you have good lighting.

@magspag Thanx for the advice. We wanted to save some cost by not replacing the floor tiles, as well as save by retaining the upper cabinet in its current grey shade. Guess we will go for all-black for the cabinets: both below and above the counter; and put in a new counter-top that contrasts--maybe, a light coloured granite or slate. Examples for this color-scheme are in the ideabook

Unfortunately all your options require custom work: It looks like you need an 18" corner cabinet. You will have to modify the last wall cabinet on the left. As I am eyeballing it, you should be able to cut the last cabinet in the middle and then shorten the left section to fit the space of the wall next to the door trim. It's an option that makes the area looks symmetric. Or you can install shelves over the sink. I would not recommend it because it will take the looks away. And the last option will be to remove the last cabinet, shorten it so it fits over the sink and install a single cabinet where the double one was. This will leave a triangle space behind the corner where the two cabinets will meet. You can block the space under it. Hope this helps!

Go for Asian Paint Re-painting Process Repainting is done when your home is already painted once. It is required when you need to decorate the house afresh or old painted walls are not in good condition. Step I – Prepare Wall for Painting 1. Scrap the old paint using sand paper to remove falkes, loose particles. 2. Fill the cracks, pores, damages using putty – wherever required. Please note – putty is not required in re-painting in general, however one of coat of it can be used if walls are damaged badly. Step II - Apply Primer 1. Apply one coat of primer to smoothen the surface. 2. Let is dry for few hours. Step III – Apply Paint/ Designer Walls. 1. Apply two coat of paint successively after drying the first coat. 2. Or Get your texture/stencil/design work done Please Note- Primer is a must for Designer Walls. Fresh Painting What is Fresh Painting and when it is required? In general we do Fresh Painting in newly constructed home, apartments. In Fresh painting walls are completely rough. Some times in old houses fresh painting is also needed when its wall condition is really bad, damaged or outer layer of old paint is completely broken. Step I – Apply Primer and Putty. Primer is a preparatory coating put on materials before painting. Priming ensures better adhesion of paint to the surface, increases paint durability, and provides additional protection for the material being painted. So primer is always used in fresh painting. Putty is generally used for filling the minor cracks, wholes, damages to level the surface for painting. Putty is a generic term for a material with high plasticity, similar in texture to clay or dough, typically used in domestic construction and repair as a sealant or filler. 1. Apply One Coat of Primer, let it dry for approx 2 hours. 2. Apply One Coat of Putty on Newly Constructed Wall as base. 3. Let it dry for some time let say approx. 3-4 hours. 4. Apply Second Coat of Putty and Let it dry again for few hours. 5. Use Sand Paper for smoothening or levelling of wall surface. 6. Apply Second Coat of Primer after drying the putty. Step II - Apply Paint 1. Get the requested products which need to be used, verify the color code, pour the paint in bucket and mix some amount of water. 2. Apply first coat of paint using roller and brush. 3. Let it dry for some hours and apply the second coat of Paint. 4. Final touchup if finishing is needed. Take care of all above process