I suggest you follow the step-by-step guide for creating storage cabinets under the bathroom sink. Take proper measurements - Measure the available available space in height, width and height. Cut Plywood to size - With a circular saw and framing square, cut all the required pieces out. You can use a sliding compound saw as an alternative. Attach the base and sides - Start assembling the sink cabinets by placing the bottom piece of plywood sheet on a flat surface. Attach the back and top boards - Place the plywood sheet for the top part of the cabinet and attach wood screws to connect it to both the sides. Turn the back faces of the cabinet upwards. Keep the back piece over the structure and fix it into place with wood screws. Attach shelves - Place the cabinet in an upright position to install the shelves. Slide a shelf into the structure so it is flush against the back. Attach door - Keep both hinges of the door on the same side of the plywood sheet. Drill them using wood screws into place. Now keep the door over the cabinet structure, extend the hinges to one of the side panels and fix them to make them secure. Fix a hasp closure on the other side of the door, placing it in the center of the hinges.

Rui, On the contrary, If you look from the left it should align with the base cabinet because they are in same size. Most likely, it will go off by 3/8 of an inch after the dish washer (as it has been wiggled in). It is too small a difference to be noticed by average person because they are at different heights. We are suggesting to change either the cabinet above sink or the single box above right of dishwasher. It will be easier and the filler will be least noticeable above the sink as the shutters are already of a different size. Good news, is that you may have the cabinet boxes already. You can check by placing them starting from the left most wall whether the above suggestion works for you. Thanks, Nitin Cornerstone Designs, Bangalore.

Hi Karuna, Here are a few pros and cons of using large tiles on walls - Pros - 1] They have lesser joints to fill and hence give the space a larger look and feel. 2] They look like stone cladding if installed properly. Cons - 1] They are costly as far as their rate/square foot and labour cost is concerned. 2] They require epoxy grout / adhesive instead of the regular cement grout which usually adds to the cost. 3] Since they are huge in size, they are not suitable for small areas due to the hassle of cutting the tiles manually to fir the size. 4] There is a high possibility of warp age in the tiles due to their size and because of this either their joints wont match or the surface may look undulated. Hence, it is recommended that large tiles be used for floors instead of walls. We would suggest to go in for the smaller sized tiles like 2'x2' or less for a more aesthetic look. Just apply tiles between the kitchen cabinets and avoid doing so near the peninsula. It would make the kitchen look lighter and brighter and not like a bathroom. Also for the back splash you may go for any of the following tile options - 1] Mosaic 2] Ceramic tiles/ Vitrified tiles 3] Natural stone such as granite All the best! Regards, RnD Atelier Nagpur

@Cornerstone design studio: Apologies for making big post; thought that more info will help. @Rupal ji, If it sounds like I dont need any changes; my apologies for that. Let me put it in short,"I am looking for options that give modern facilities without leaving good things from old charm/ comforts. " Thanks for the straight forward comments. I shall try to edit my original post to make it simpler and that looks open to new ideas.