Pankaj, I just realized that initially you told us that the bathroom area was 12'-0" x 9'-0" and later you mentioned that it was 11'-8" x 8'-0". In the last floor plan, I forgot to change the bathroom with the new dimensions. Below is the floor plan with the correct dimensions for the bathroom. The bedroom is ok, I drew it 19'-2" x 12'-6". The new layout does not change the way things are placed. Everything still fit. The only difference is that the vanity is now 4'-4" long instead of 4'-8". and the toilet is closer to the shower by 1'-0". Can you give me the lengths of the walls K and L. They are the walls between the vanity and the shower area. I will send you the new layout once you give me the length of these 2 walls.

Thanks a lot for your comment. I wouldn't exactly call it a walk in-closet. As you can see from the drawing, Its space provided for two single wardrobe (one on each side). Maximum width can be around 3.5 ft. The humidity point is quite relevant. The question is would it be possible to include a wet room in the space i.e. 6ft x 8.6ft. - considering I don't remove the dress wall. Wanted to get a sense on the possible layout. Thanks and look forward to your advise.

I suggest you follow the step-by-step guide for creating storage cabinets under the bathroom sink. Take proper measurements - Measure the available available space in height, width and height. Cut Plywood to size - With a circular saw and framing square, cut all the required pieces out. You can use a sliding compound saw as an alternative. Attach the base and sides - Start assembling the sink cabinets by placing the bottom piece of plywood sheet on a flat surface. Attach the back and top boards - Place the plywood sheet for the top part of the cabinet and attach wood screws to connect it to both the sides. Turn the back faces of the cabinet upwards. Keep the back piece over the structure and fix it into place with wood screws. Attach shelves - Place the cabinet in an upright position to install the shelves. Slide a shelf into the structure so it is flush against the back. Attach door - Keep both hinges of the door on the same side of the plywood sheet. Drill them using wood screws into place. Now keep the door over the cabinet structure, extend the hinges to one of the side panels and fix them to make them secure. Fix a hasp closure on the other side of the door, placing it in the center of the hinges.

I have the same kind of bathroom and saw the same video. I used an angle grinder to remove one of the walls. You have to have hearing, breathing, and eye protection. I don't think there is any way to avoid the dust. I'm going to direct a fan to an open window in the bathroom. My sinks are top mount so there was no problem removing it. I replaced the faucet only for now. I also changed out the drain and stopper. The old one was rusted to the sink. I had to bang on it with my loader from my tractor with the sink upside down to get it off, lol. I have put off removing the rest of the wall and the cabinet because it is such an ordeal. You might check with Daltile to see if they still make the tile. Maybe try cutting away the cabinet while keeping the counterop supported and then dropping it so that the joint gets more exposed? I'll be interested to know if you get to this before me but I'm doing an entire gut job.