A houzz contributor, not too long ago, had made a wine rack out of 4'x4' wooden pallets, that are used in the US to move a load of goods with a fork-lift truck. Perhaps they have them in your country. He cut them in half so they were only two feet deep and stacked them up to high counter height. The wood would be a nice contrast with your concrete, might add a little warmth to the space. cascio.offsite@gmail.com

I have discussed your design with my family.I likes it. some suggestions shall I change the cook top and sink in the main kitchen to each other. Because according to our tradition we have to cook by facing East or North.the window side is the east. Similarly shall we move fridge to the right end of the kitchen.(to the south Side) then I can place the mixer at there where the fridge now is.Is it convenient .i don't know how to convince my family about this design. ours is an orthodox one. Its not a matter to be discussed here. I hope I can.Any way i like this

The wall is stunning and creative, but sadly, I have to agree with the consensus expressed on all your threads: this wood should have been bone dry, carefully checked over piece by piece for holes, insects, existing fungus etc., and probably treated and certainly well sealed before before being installed. At this point, I would cut my losses and take it down. Once the pieces are all down, it's possible that if you thoroughly scrub off all fungus with a bleach solution, then let them dry bone dry (preferably in a wood kiln or perhaps a DIY drying shed), then treat and coat, these pieces could be reinstalled. Even that depends on the conditions they'll see - if this wall is exposed to lots of steam or grease you'll be having new issues before long. Also, is the wall itself dry and solid? Any chance water is leaking or oozing from somewhere and adding to the issue? What species of wood is this? Some species are naturally more fungus resistant and appropriate for this than others. Long story short, I'd recommend finding a different way to cover the wall - with ceramic, galvanized metal, or with a really scrub-resistant paint.

Hi. I hope the counter is thick enough to take the weight of the sink and water. atleast 25mm to drill in the undermount sink clips. Drill clips are available easy, you can look up Blanco and Franke EL undermount clips. If the counter is thin, you risk cracking while drilling, in which case it is better to use epoxy sink clips. A brand you can find in India is Solartime. They are expensive but you can get your local fabricator to make you a dozen clips and get them galvanised to prevent rusting. Do remember to apply silicone sealant between the undermount sink and the quartz generously. I know how you feel, things that are easily done in the west can be a pain to achieve in our country, especially places other than major cities.