Raj - What you say is true that a lot of interior design's margin is in furniture. I will not sugar coat it. And many designers may seem to be more interested in that when you bring them in. But I have had several clients call me over the years saying they are building a new home and would like to consult primarily on layout. When you speak to someone is tell them you are not ready to order furnishings or window treatments, but that you would like a contract that focuses on layout, planning, and interior detailing (i.e. doors, trims, floors) - i.e. the bones of the house. What I would suggest is when you call for a designer, you be prepared to pay a good consultation fee. A good rule of thumb is that you can expect to pay between $3-$10 per square foot of your home depending on the area of your country and the expertise/experience of the designer. If you are not averse to paying this type of fee, and communicate to the designer that your interest is in getting the best solutions, not in purchasing furniture at this time, I'm sure you will be able to get the level of service you desire. If someone you talk to doesn't seem thrilled to provide this kind of service, move on to the next person. Don't rely on "fame" or how well known someone is. They may be well known for doing show houses or just because they've been in the field the longest in your area. Not because they're the right fit for you. You could also check the Houzz directory for good designers in your area. The difficulty is that there are often decorators whose expertise and focus is really just on furnishings not so much on construction - and they serve a purpose for their clients. But there are other designers who provide more of a wholistic approach and have more familiarity with building a new home. These are the people you should seek out. Houzz is a fantastic community - and as I said you may get good advice here but there's really no replacement for someone to work with you in person. Sorry for the super long post but I feel passionately about this and I think this advice will best suit your needs.

This is a common practice especially in asian countries where the kitchen is much smaller.

Hi, I am from Assam, Guwahati. Yes it is warm humid place with lot of rains (like kerala). The bookcase is gradually drying. Fortunately last few days were very sunny and airy and my room has two big windows. Few mor details of my bookcase. It is 8 feet wide, 6 feet tall and 11 inch deep. It was attached with wall with 6 wall screw and has four pair of legs.I ask the carpenter to divide the bookcase into 3 part (32 inch each) and two door system for each part. Every part has 6 shelve from top to botom. There is no plywood or wood in back. I made it that way because the bookcase is attached in my room's inner wall I understand that the bookcase may have very little gap in between wall and wooden planks and i am ready for it. But I have no idea that beacuse of faulty mesurement, it became 1 inch gap between wall and sheve in the upper side. In lower side it is very minimum gap. I stop the carpenters to put the glass door. But now I see that they also make fault in making the doors. The doors are heavier that the shelf. The wooden planks are 1 inch thick while the door are 1.1/2 inch thick. I actually visit few hardwere shops here, but most have no ideas what to do and few says to apply wall putty to fill the gap. But my back wall is coloured (old wall, that why) and wall putty will not set on old wall and timber. I cannot remove it now from the wall otherwise the wall may destroyed. I really need a step by step guide now that what to do after the heves are dry, how to fil the gap and how to put the door without further damaging the shelf.

One of my clients had no designated space for puja in their home, and they would have had to squeeze it into a passage somewhere. So when they came to me for ideas, I noticed in the floor plan that they had a beautiful covered verandah overlooking a private garden. The wall of that verandah was towards the east side of the garden. So I thought- why not carve out a rustic simple puja space here? Outdoors? The client was game. And this was the result- a 2'-0" x 2'-6" wood panelled niche in the wall, with a simple clay Krishna placed on a wooden bracket with a delicate hanging brass lamp