Already you have left space for 18mm thk single glass.. to insert inside the hollow gap.. A;so a electrical wires in been kept on top, i dont know how u where u wanna used that for, there is no sandwich type glass space over there... Wood u hav already used for panelling & u r looking for glass.. wat type to take... My suggestion will be, u go for clear toughened glass, so that on one side u can fix film, ,,, so that any time if u feel like to change the design u can. but if u for for designer glass or decorative glass, which will not alter later, that will be one time large investment for u ,,, But changing the film will not disturb the entire partition and glass , only reasonable price u can change the entire film as per latest trendz

This is wonderful how you opened the stairs - you get a real sense of the architecture and it brings in more light. I applaud what you have accomplished. I'm going to assume that the wall above is patched with quickcrete and the whole thing is painted (try to get the wall beyond under the stair too). If you have / want a flat screen, you might mount a swing arm wall mount for a flat panel television on the vertical wall element remaining on the right - just about 3' - 3 1/2' (around 1 meter) above the floor so that it is eye level when you are sitting. The swing arm support will allow you to tilt the television away from the wall ever so slightly across the nearby corner. This can help to eliminate glare from the nearby window and make it possible for more people in the room to view it / expand your seating possibilities. I reference something like http://www.cdw.com/shop/products/Chief-Thinstall-TS318SU-Medium-Dual-Swing-Arm-Wall-Mount-18in-Extension/2555661.aspx?cm_mmc=ShoppingFeeds-_-GoogleBase-_-Video/Monitors/Cards/Projector-_-2555661_Chief%20Thinstall%20TS318SU%20Medium%20Dual%20Swing%20Arm%20Wall%20Mount%20-%2018%22%22%20Extension%20-%20_CIF-TS318SU You can even mount a television tlhat is wider than the wall behind as it can sit flat on the wall and extend beyond the wall to the left when at rest like another plane in your architectural composition. Since the upper stair is just behind, this should be fairly safe for the electronic. Determine precisely where the television will be at rest before you hang the mount itself. Then, look for a low height chest to sit below the television. Ideally a chest with one open shelf near the top to hold your component receivers. You may want to try to run electrical to the remaining vertical wall on the right (the support for the stair landing) to get power into the wall itself, while everything is open. Depending upon where the nearest source is, with concrete walls, you could mount the power junction box low on the wall under the stair and drill out small diameter cord passages through the wall after placement of your components. Or use the baseboard area to run needed cables and power to the area behind the chest, then conceal it with baseboard trim. The more you can hide the power and connection cords, the sleeker the look, to match your gorgeous architectural stair element. If you have a larger deeper television, put it on a sideboard chest under the upper stair where you have the depth. In the rear area, take care with putting cables together in a cord cover - ikea has a good one that is inexpensive. http://www.ikea.com/us/en/catalog/products/20097954/ so it looks "neat" from behind when you come down the stair.

A houzz contributor, not too long ago, had made a wine rack out of 4'x4' wooden pallets, that are used in the US to move a load of goods with a fork-lift truck. Perhaps they have them in your country. He cut them in half so they were only two feet deep and stacked them up to high counter height. The wood would be a nice contrast with your concrete, might add a little warmth to the space. cascio.offsite@gmail.com

m sorry ...for not reading carefully...just wait I'll try