If the door is well painted I doubt if you will have a problem. A good coat of paint on wood work and wall surfaces is important if you have a lot of moisture in the room. If you can do some alterations to the space I would suggest you install an exhaust fan in the ceiling that vents moisture to the exterior, i.e. through the roof or side wall. Companies like Nu-tone and Broan make fans that have a moisture sensor that will kick on the fan while using the shower if you forget to turn it on. And these fans can be much more quiet than the typical bathroom fan. Some hundreds of dollars for the purchase and installation of this would be well worth it. I have seen bathroom ceilings covered with mold because the room has neither a neither a fan or window so you are right to be concerned.

I am so happy to see you here! I will have to go back and see if i can retrieve my posts... thought I would make them into a little book for my daughter, with photos. Quick run-down on the bathroom (not travels, no time) - The kitchen has a rather elegant sliding door with beveled glass panels. Painted white, since this was the original colour. GD's new bathroom has the doors I had picked earlier; i thought of polishing them but decided sprayed automobile paint (on a resin primer) would wear better. Especially since it is such a small bathroom, and she is so splashy. I have this finish in my kitchen and it has lasted 15 years now. A tad chipped here and there, but only needs a wipe down once a week. Same finish for the balcony doors, also split like the bathroom. We have a new wardrobe, a study table with built-in shelves, and a small chest of drawers for her odds and ends. I want to re-tile the tiny balcony, more as a little statement. Currently we are looking at Portuguese tiles, though I did think a mosaic with a funky cat might be nice. Let me see the costing. The room will be painted a neutral adobe, with bright white woodwork and an off-white ceiling. This means she can go wild with cushions and covers. Other changes in the flat; We have changed the glass in the master bedroom and living room from small cramped panes to a single pane for each section with a 1" bevel all round. Doubles the cost of the glass, but looks so elegant! The air-conditioning is being re-located. The compressors were all mounted in the bedroom and living room balconies, which looked terrible and meant the balconies (very narrow, only 30" deep) couldn't be used for anything. Not even plants. So they are being moved so that the compressors can be mounted at the rear of the building. two down, one to go. Now we can put in some nice plants, fishtail palms etc. The kitchen counter on one side came out intact and will be reused elsewhere. I am planning overhead storage, cupboards, and a draining cupboard for plates and glasses. Right now there is no dish washer, though a place is earmarked, but for now I will put in a cupboard with steel racks for cups, glasses and plates, all hidden behind pressed glass doors. This is all in the planning stage.... Pictures in a little while, they are mostly on my ipad and don't transfer well to the mac. They come without numbers... so I have to rename the or something. Somebody tell me how to do this!

Hello Radha, I don't think any independent comparison study will be available. You may go for a localised product with nano coating. BTW, almost every one uses a St Gobain, Modi toughened glass for these fixtures. Thanks, Amit Cornerstone Designs, Bangalore.

Greetings from Dream Design, You can convert it into washing storage area as taps connections are already there Pls see the refrence