I think your inclination toward rustic and distressed pieces is the right way to go. Consider a movable coffee table - I see 2 recliners that may necessitate some table shifting?- an area rug large enough to incorporate all the seating, rather than just a hearth rug, and enclosed storage for your electronics. If you can post shots of the room, other Houzers may have some more ideas.

You can also think on panel work with some openable shutters which can hide the boards as well give an access to use when needed . Bottom can be a sleek storage with louvers where inverter can get tucked in and also a seat or a ledge used for multipurpose. One thing to remember this set out would not be budgeted but, can allow you to explore option to make it look good or articulate well.

Dear Ajmir, First you decide yourself Why and What you want to modify so that you are clear about your requirements. (Add some images of the old house as well). Then post these requirements here on Houzz. Only then professional would be able to understand the scope based on your requirements and respond to you accordingly.

Hey!! You could go about this two ways, First, is to upholster the bench itself (making the change semi-permanent), or the second would be to place cushions, or a think upholstered piece of ply atop the bench and secure it with fabric straps across the four legs. If you want to upholster the back as well, you'll have to glue the foam and fabric onto a plyboard and attach it (in both cases). Read on for instructions. For the first option, you have to follow the same steps with the exception of 12, and do it all directly on the bench and not on a plyboard. Procure a 6mm thick plyboard and cut it to the dimensions of the seat. make it a 1 or 2 mm smaller than the seat so that you can slide/drop it in when done. sand one surface down to make it smooth. Get 3" foam, again cut to the size of the plyboard. get foam batting =, and fabric if your choice, 6" larger on all sides. Spray adhesive on the ply and foam (check manufacturers instructions to see whether you need it on both surfaces or just one.) Glue the foam to the board, place weights on top, and leave it to dry. Lay down the fabric, face down on a clean workstation, play the foam batting on top. Place the now glued seat upside down on the batting and start pulling the batting upward and staple it in place. Do one side at a time (opposites first, not adjacent) Repeat the 8 and 9 with Fabric Cut off any excess. Tailor longish strips of the fabric and staple them to the four corners of the ply and use it to tie and secure the board on the bench. Hope this helps!!