I am so happy to see you here! I will have to go back and see if i can retrieve my posts... thought I would make them into a little book for my daughter, with photos. Quick run-down on the bathroom (not travels, no time) - The kitchen has a rather elegant sliding door with beveled glass panels. Painted white, since this was the original colour. GD's new bathroom has the doors I had picked earlier; i thought of polishing them but decided sprayed automobile paint (on a resin primer) would wear better. Especially since it is such a small bathroom, and she is so splashy. I have this finish in my kitchen and it has lasted 15 years now. A tad chipped here and there, but only needs a wipe down once a week. Same finish for the balcony doors, also split like the bathroom. We have a new wardrobe, a study table with built-in shelves, and a small chest of drawers for her odds and ends. I want to re-tile the tiny balcony, more as a little statement. Currently we are looking at Portuguese tiles, though I did think a mosaic with a funky cat might be nice. Let me see the costing. The room will be painted a neutral adobe, with bright white woodwork and an off-white ceiling. This means she can go wild with cushions and covers. Other changes in the flat; We have changed the glass in the master bedroom and living room from small cramped panes to a single pane for each section with a 1" bevel all round. Doubles the cost of the glass, but looks so elegant! The air-conditioning is being re-located. The compressors were all mounted in the bedroom and living room balconies, which looked terrible and meant the balconies (very narrow, only 30" deep) couldn't be used for anything. Not even plants. So they are being moved so that the compressors can be mounted at the rear of the building. two down, one to go. Now we can put in some nice plants, fishtail palms etc. The kitchen counter on one side came out intact and will be reused elsewhere. I am planning overhead storage, cupboards, and a draining cupboard for plates and glasses. Right now there is no dish washer, though a place is earmarked, but for now I will put in a cupboard with steel racks for cups, glasses and plates, all hidden behind pressed glass doors. This is all in the planning stage.... Pictures in a little while, they are mostly on my ipad and don't transfer well to the mac. They come without numbers... so I have to rename the or something. Somebody tell me how to do this!

Hi. I hope the counter is thick enough to take the weight of the sink and water. atleast 25mm to drill in the undermount sink clips. Drill clips are available easy, you can look up Blanco and Franke EL undermount clips. If the counter is thin, you risk cracking while drilling, in which case it is better to use epoxy sink clips. A brand you can find in India is Solartime. They are expensive but you can get your local fabricator to make you a dozen clips and get them galvanised to prevent rusting. Do remember to apply silicone sealant between the undermount sink and the quartz generously. I know how you feel, things that are easily done in the west can be a pain to achieve in our country, especially places other than major cities.

Please Read, 1) Following are the photos of my Mumbai apartment (10th floor) kitchen. Water heater and water purifier were already (haphazardly) installed by my contractor before I came to occupy the apartment. Answer : u can shift the purifier above sink , inside the cabinet which will be made by carpenter. 2) We now have to install cabinets above the counter. ( you can ) no problem. 3) I want to get the PNG gas pipes installed to replace the existing cylinders. Answer : This work you can do after carpentry work. 4) When I saw other homes it appears I not only need pipes but some ghastly looking meters/ valves etc. Answer : meter will be hidden inside above cabinet toward right side and pipes will be inside the hob side counter will transfer through the balcony wall to meter again. 1) The gas pipes will come from the wall next to the balcony doors. The sink is just next to this wall. Will it be possible to install the pipes and meters below the cooking counter or is that not practical? - - Don't know what are all the practical considerations. Safety, access to meter to take readings, location of the sink? ). everything is possible.. 2) If under the counter installation is not practical, where should the pipes and other boxes/meters go? as mentioned above.. 3) Is there any practical solution to clean up the wall with water purifier and heater? (please note the kitchen has a 6" thick beam on the top of the wall above the counter, also 6" think pillars one in the corner and the other large one near the microwave as shown. Additionally it has a protrusion on the ceiling, probably this houses the drain for the apartment above me. ( for above apartment kitchen nahani trap chamber it is... )

Thanks for both of your responses CUBSpaces team and Shweta from Shades studio. It really gives a clarity about possible consequences. I am now doubt free about changing whole things in Bathroom as it will be interconnected. However will appreciate your opinion on few things: 1. Kitchen wall tiles: I have those from countertop height to roof(almost area of 6X15 feet) which are good and not hollow. I changed countertop 5 years back without any damage to these tiles. It might cost me another 10-15 K, but I feel the whole process and quantity of wasting old good tiles makes me little sad. 2. kitchen countertop: Made new around 5 years back. I don't expect to get it all intact. But large pieces can be cut and can be used as top for other freestanding structures like dishwasher, front load washer, heighten base cabinets, etc. 3. Plywood: I don't mind giving enough labour charges for old sheets recycle. I am planning to use doors, loose sheets(like kept on bed frame of settee frame.) or parts of big frames like settee. I am keen on reducing waste than to save money. You can see various DIY ideas by western people, who remove or sand laminates and re-paint furniture, or carefully remove hollow tiles and re-attach them. Some are also re-painting ceramic tiles. I am just asking myself: Are we creating more and more waste by use and throw approach every 10-15 years, just because we can afford it?