It seems the WC would be better on the top wall with the vanity. If you have a walk-in shower, it doesn't need to be quite so wide, and you can move the entrance to the bottom to be more generous. If you have a tub/shower combo, you don't need the partition at all. Consider flipping the door swing unless you're really concerned with privacy.

So for this to work, you need to go back through my question and make sure you have answered all of them the best you can. Is the electrical outlet for the counter space going to be right next to the switch, or is it that blurred spot that I see in the picture, . If your walls are Travertine marble, and there are not already electrical boxes in the exact location the lights go, we are going to have a hard time. If a 30" vanity goes in the corner, and you leave 5" on each side for the lights, that leaves a 20" mirror with one light jammed tight into the corner. So if we leave another inch on both sides, for clearance, that leaves 18" mirror. If you put a 3" frame around the mirror mirror, that only allows for 12" of actual mirror. I don't think that is enough mirror. Your bath is too narrow for a mirrored cabinet with built in lights unless it is recessed into th wall. The plumbing is probably in the way for that. Give me your thoughts on what I have just said, and then go back and answer all my questions. Then we can take it from there with a narrower down and focused search.

Following are my comments : 1.Buying cheaper branded sanitary fittings is only possible when you buy the same in bulk quantities. But I would like to highlight that these are one of the most important fixtures in the stated space. Don't compromise on the quality of it if you want them to survive the long run.(You can go for the Jaquar continental series or change to Parryware) You can certainly compromise on the WC & the WB since even brands like Somany give good ceramic fixtures at relatively low cost. There you can save your bucks. 2. I haven't worked on PVC vanity but can comment that marine ply cabinets also stand well for the wear and tear. 3. You can go ahead with just the glass partition avoiding the cubicle door. 4. Yes you can but the selection should be on the lighter side of the colour palette so that the bathroom should not look more claustrophobic due to its small size(2 m x 3.5m which is normal in today's real estate market in mumbai). Ar. Amol Bhopi AVB Architecture Mumbai 71.

Thanks for both of your responses CUBSpaces team and Shweta from Shades studio. It really gives a clarity about possible consequences. I am now doubt free about changing whole things in Bathroom as it will be interconnected. However will appreciate your opinion on few things: 1. Kitchen wall tiles: I have those from countertop height to roof(almost area of 6X15 feet) which are good and not hollow. I changed countertop 5 years back without any damage to these tiles. It might cost me another 10-15 K, but I feel the whole process and quantity of wasting old good tiles makes me little sad. 2. kitchen countertop: Made new around 5 years back. I don't expect to get it all intact. But large pieces can be cut and can be used as top for other freestanding structures like dishwasher, front load washer, heighten base cabinets, etc. 3. Plywood: I don't mind giving enough labour charges for old sheets recycle. I am planning to use doors, loose sheets(like kept on bed frame of settee frame.) or parts of big frames like settee. I am keen on reducing waste than to save money. You can see various DIY ideas by western people, who remove or sand laminates and re-paint furniture, or carefully remove hollow tiles and re-attach them. Some are also re-painting ceramic tiles. I am just asking myself: Are we creating more and more waste by use and throw approach every 10-15 years, just because we can afford it?