Thanks Pragati, it looked to me like some sort of high polished quartz stone and if this was the case there would be a way to hide these joints by filling them with an appropriate material and polish them thereafter. So I guess, the framing-idea with the LED-Strips which pollyannagal mentioned would be a good option. You could also tape some sort of accent-tape over the joints or even just LED-Strips to hide these ugly joints. Cheers Bertram

Are you saying you will be layering a wooden false wall on top of the existing wall to hold the pocket door? If that is the case, you might want to treat the entire side of that new and existing wall ( including the area above doorway) as an accent wall using wood veneer strips. They look like actual pieces of wood plank which have adhesive backing, they come in a variety of finishes and colors...I like the old reclaimed wood look. A diagonal pattern would add extra visual interest, but would be more intense to cut and install. That will camouflage the additional layer and create a beautiful accent wall.

Steel Cementitious Panel (ZT50-A-C5) Raised Floor System Wire Trunking System: A workstation can be easily and quickly relocated with cable management without disruption. Convenient for connecting wire at any point without cutting floor. Suitable for all kinds of plug socket terminals. Adjustable wire-connected location.

Hey!! You could go about this two ways, First, is to upholster the bench itself (making the change semi-permanent), or the second would be to place cushions, or a think upholstered piece of ply atop the bench and secure it with fabric straps across the four legs. If you want to upholster the back as well, you'll have to glue the foam and fabric onto a plyboard and attach it (in both cases). Read on for instructions. For the first option, you have to follow the same steps with the exception of 12, and do it all directly on the bench and not on a plyboard. Procure a 6mm thick plyboard and cut it to the dimensions of the seat. make it a 1 or 2 mm smaller than the seat so that you can slide/drop it in when done. sand one surface down to make it smooth. Get 3" foam, again cut to the size of the plyboard. get foam batting =, and fabric if your choice, 6" larger on all sides. Spray adhesive on the ply and foam (check manufacturers instructions to see whether you need it on both surfaces or just one.) Glue the foam to the board, place weights on top, and leave it to dry. Lay down the fabric, face down on a clean workstation, play the foam batting on top. Place the now glued seat upside down on the batting and start pulling the batting upward and staple it in place. Do one side at a time (opposites first, not adjacent) Repeat the 8 and 9 with Fabric Cut off any excess. Tailor longish strips of the fabric and staple them to the four corners of the ply and use it to tie and secure the board on the bench. Hope this helps!!