You're dreaming. Lovely to look at but....where do the toothbrush and toothpaste and hand soap and brush and comb go? In that drawer you need to stoop to reach? Or do you carry them in from somewhere else each morning? To make this a working bathroom you need cabinets to hide things or shelves to put things on.This sleek vanity invites unsightly clutter to mess it up in real time. And that faucet is not one i'd recommend: i have one so i know. A drippy hand reaches to shut off the water and all those drops from your hand land on the shiney chrome spigot and gets it water-spotted with every use. Extremely unsightly and annoying.Also ours started leaking from the gap between the control and the upward tube leaving streaks of calcium deposits along its entire length. You'll be working MORE to keep this bathroom looking clean and tidy cuz there's not sufficient nor practical storage to hide stuff...But I agree...it's beautiful.

Hi. I hope the counter is thick enough to take the weight of the sink and water. atleast 25mm to drill in the undermount sink clips. Drill clips are available easy, you can look up Blanco and Franke EL undermount clips. If the counter is thin, you risk cracking while drilling, in which case it is better to use epoxy sink clips. A brand you can find in India is Solartime. They are expensive but you can get your local fabricator to make you a dozen clips and get them galvanised to prevent rusting. Do remember to apply silicone sealant between the undermount sink and the quartz generously. I know how you feel, things that are easily done in the west can be a pain to achieve in our country, especially places other than major cities.

Hi! Yeah it will. You will have to get your plumbing lines capped and replaced. It's not advisable to have a joint in the plumbing line. So the one that you are wanting to pull to the new sink will need a fresh line put in from the last bend it has. I hope that makes sense! Best! Miloni

I have the same kind of bathroom and saw the same video. I used an angle grinder to remove one of the walls. You have to have hearing, breathing, and eye protection. I don't think there is any way to avoid the dust. I'm going to direct a fan to an open window in the bathroom. My sinks are top mount so there was no problem removing it. I replaced the faucet only for now. I also changed out the drain and stopper. The old one was rusted to the sink. I had to bang on it with my loader from my tractor with the sink upside down to get it off, lol. I have put off removing the rest of the wall and the cabinet because it is such an ordeal. You might check with Daltile to see if they still make the tile. Maybe try cutting away the cabinet while keeping the counterop supported and then dropping it so that the joint gets more exposed? I'll be interested to know if you get to this before me but I'm doing an entire gut job.