The wood has to reach what's called Equilibrium Moisture Content (EMC), which is different for various areas of the country/world. I don't know about end grain slabs, which is what you have, but the rule of thumb for lumber air drying (vs. kiln drying) is 1 year for each inch of thickness. Moisture leaves the end grain faster than the side and/or edge of the boards, so in your case the drying time will probably be shorter. If it is not dried in a controlled environment your slabs are going to split radially, due to drying too fast.

Hi Mr. Narayansingh, You can go for some stone cladding on the exterior surfaces of the wall. You can wooden doors and wooden framed windows. You can use grey colour textured stone cladding in the half/few portion of the elevation. Thanks

Hi, I am from Assam, Guwahati. Yes it is warm humid place with lot of rains (like kerala). The bookcase is gradually drying. Fortunately last few days were very sunny and airy and my room has two big windows. Few mor details of my bookcase. It is 8 feet wide, 6 feet tall and 11 inch deep. It was attached with wall with 6 wall screw and has four pair of legs.I ask the carpenter to divide the bookcase into 3 part (32 inch each) and two door system for each part. Every part has 6 shelve from top to botom. There is no plywood or wood in back. I made it that way because the bookcase is attached in my room's inner wall I understand that the bookcase may have very little gap in between wall and wooden planks and i am ready for it. But I have no idea that beacuse of faulty mesurement, it became 1 inch gap between wall and sheve in the upper side. In lower side it is very minimum gap. I stop the carpenters to put the glass door. But now I see that they also make fault in making the doors. The doors are heavier that the shelf. The wooden planks are 1 inch thick while the door are 1.1/2 inch thick. I actually visit few hardwere shops here, but most have no ideas what to do and few says to apply wall putty to fill the gap. But my back wall is coloured (old wall, that why) and wall putty will not set on old wall and timber. I cannot remove it now from the wall otherwise the wall may destroyed. I really need a step by step guide now that what to do after the heves are dry, how to fil the gap and how to put the door without further damaging the shelf.

Anita Vitrified tiles by themselves do not particularly allow the walls to breathe, and hence are prone to cracking. That being said they do not collect moss either. If you are however set on using these tiles, I suggest you use them in a mosaic fashion, where smaller tiles or broken pieces are used. This will allow the wall to breathe, though the moss collection might be more due to the greater amount of grating.