Best brand of brass drawer pulls and knobs??
TxMomma
2 years ago
Featured Answer
Sort by:Oldest
Comments (10)
jck910
2 years ago
PROThe Kitchen Place
2 years agoTake a look at Hardware Resources "Jeffrey Alexander Series" and their SBZ finish....called Satin Bronze. Looks a lot like matte brass but more subtle (less yellowy) and I'm selling a lot of it!
Sorry this is so blurry....I can take a closer up photo if you need me to.
Related Discussions
Reviews for kitchen appliance brands
Comments (122)I had purchased hafele hob 10 months back... I got it serviced 6 times... Now i requested for replacement with new one... Still they have not attended my request......See MorePlanning for disability
Comments (228)Tsilanko, I would always recommend professional installation where needed. But what I am doing here is suggesting that WHEN you are planning to build or renovate, to consider how your plans will affect you in 20 or 30 years time. Split levels are very hep when you are young. A kitchen 3 steps down at 30 is rarely a problem, but might be a hazard at 60, or, as Marjie1059 suggested, if you break a leg. ... All my parents' homes were terrible for old people. They were forced to move to a bungalow in extreme old sge because the location and design of their home was more suitable for an active young couple with a large family than for an elderly couple with stroke disabilities. I would not want to move again, so my present home has features built in that make ageing in place simpler. Mostly small changes, like grab rails, and lever handles on doors and faucets. A major disability suddenly suffered requires major changes if permanent. I did look at this because it came up in the discussion, but if you look at the heading, Planning for Disability, it means just that. Plan ahead so you don't have to make expensive changes later on. But thank you for your advice, yes, major changes are not in the DIY domain....See MoreHELP Any designer Done kitchen with these shades of merino laminates ?
Comments (43)Hi Cornerstone, I read your feedback 1. Profile handles I was late as the doors were already ready and it was too much of re-work. Regarding putting handles 2. Sharp edge can cause problem thats why the handles I have put are rounded on the edge not to hurt. 3. Where I did make a mistake was Did not put fillers. If I had put fillers on the sides the door issues could be resolved The upper cabinet handles. This is actually not my fault I had told them to put the handles in the center but they thought these are not drawers but rather cabinets so they should be put in the location where we put the vertical handles. By the time I came to check it was too late and now I am stuck. I am thinking of putting maybe 8inch handles instead of current 5inch but not sure if that would help to improve the look. Old kitchen pictures attached they also had handles but smaller...See Morekitchen design confusion
Comments (19)Dear Mam yes cooktop will come on right side view as shown in drawing . where shall I keep dishwasher oven and refrigerator if pantry will come in store it will away from reach once we need things shall I use dunmica for my kitchen cabinets are century Laminates shall I put glossy sheets or Matte for kitchen cabinets rgds prince...See More
Holly- Kay
2 years agolast modified: 2 years agowiscokid
2 years agoTxMomma
2 years ago- PRO
The Kitchen Place
2 years agoFor anyone interested in the SBZ (satin bronze) finish by Jeffrey Alexander, here it is next to their Brushed Gold Finish. BG Left. SBZ Right.
mark1993
2 years ago
nhb22
2 years ago
Sponsored
TxMommaOriginal Author