Pankaj, I just realized that initially you told us that the bathroom area was 12'-0" x 9'-0" and later you mentioned that it was 11'-8" x 8'-0". In the last floor plan, I forgot to change the bathroom with the new dimensions. Below is the floor plan with the correct dimensions for the bathroom. The bedroom is ok, I drew it 19'-2" x 12'-6". The new layout does not change the way things are placed. Everything still fit. The only difference is that the vanity is now 4'-4" long instead of 4'-8". and the toilet is closer to the shower by 1'-0". Can you give me the lengths of the walls K and L. They are the walls between the vanity and the shower area. I will send you the new layout once you give me the length of these 2 walls.

In the layout below, I took the liberty to move to vanity and toilet so you don't enter right into the toilet. I am not sure if you have room for that since I can't see the measurements of the width of your bathroom. This is something you can discuss with your architect. The main idea of the layout below is to block the original entrance of the closet so you can have a bedroom door. The entrance to the closet/bathroom can be where your dresser is and move your dresser closer to the window. You would have a choice of a door that swings inward, outward or a pocket door. Personally, I would go with a pocket door so the bathroom would feel more spacious.

I have the same kind of bathroom and saw the same video. I used an angle grinder to remove one of the walls. You have to have hearing, breathing, and eye protection. I don't think there is any way to avoid the dust. I'm going to direct a fan to an open window in the bathroom. My sinks are top mount so there was no problem removing it. I replaced the faucet only for now. I also changed out the drain and stopper. The old one was rusted to the sink. I had to bang on it with my loader from my tractor with the sink upside down to get it off, lol. I have put off removing the rest of the wall and the cabinet because it is such an ordeal. You might check with Daltile to see if they still make the tile. Maybe try cutting away the cabinet while keeping the counterop supported and then dropping it so that the joint gets more exposed? I'll be interested to know if you get to this before me but I'm doing an entire gut job.

I am an Architect, contact me for detail design, will give 3d also, so u can easily understand how your dream home will be.