Hello Abhishek, Handling a 4-5 ft glass piece and that too at a height of 7 + ft is not only tricky but risky as well. We would not recommend you to do it yourself for changing photos/cleaning etc.in day to day usage. You can use a acrylic transparent sheet instead, make a wooden frame and have it installed with the help of magnets. Thanks, Nitin CORNERSTONE DESIGNS Bangalore

Cornerstone Design, Thanks for your response. The electrician and false ceiling folks I've engaged are very competent, and are going to take care of installing the ceiling fans (of any type or kind I buy). My only task is to find and procure appropriate fans. Regarding the loss of about 10" due to the false ceiling: I only did a simple rectangular tray drop design for lights (approx 4-6"); however, the original ceiling was not straight, and approx 2-3" extra went in straightening it at the tray edges. Since the ceiling seems (perceived) low, I do not want to make it look lower visually. I am looking for fans that will be as close as possible to the false-ceiling without effecting its sweep functionality or energy efficiency. Any suggestions on where I can get good ceiling fans in Bangalore (all brands and varieties under one roof)? I would also like to see/consider the options you've mentioned (special fan like flush fan or ceiling swing fans). Where can I see/procure these in Bangalore? Thanks!

good work :)

I have been struggling as a homeowner who is off on medical leave with watching a 3 day install by one of the 2 big box retailers on 2 59 x 24 vinyl Pella casement windows. I found the 50 foot roll of Pella Smart Flash in the garage after installation then realized they used the cheap red house wrap tape to seal the nailing fins then put the 4 inch cedar trim in and not have the proper caulk (so the cedar is not caulked 5 days after start of install and we have had thunderstorms every day but one it will rain 3 more days). I called em on it and got red tape is fine, then me demanding otherwise to "it was temporary we where going to rip all the 4 inch cedar trim boards we placed around the windows off". Mind you they cut back 12 inch Skirl cedar siding to get at the fins but then why where they going to caulk it if it was temporary. So they put the windows in and nailed em over the OSB not replacing the 4 inches of barrier when they cut thru the felt then placed the red tape over the fins and OSB). I think they should have set the saw shallower not to cut the felt? Do I need them to pull the windows out to put splice in some type of 4" barrier as I told them they should? They agreed pull the 4 inch trim off anyway to replace the "temporary" tape. Should I ask for new cedar trim boards as they will take em off with nail holes and possibly break? What about the rain getting under/in the uncaulked cedar trim(the cuts are tight thank goodness) its going to rain all week is it ok the uncaulked trim boards are getting steady rain for a almost a solid week? They showed up asking if they can use my ladder ok no longer, they did not have caulk asking me if I was going to caulk the second story windows(I am on crutches), having to reorder interior oak they did not have enough, did not have a vacuumn asked to use mine, and here i sit with windows as the rain pours down the west side of my house and windows not caulked waiting for my hip to heal. Thanks for the help! Just really disappointed in the whole job and one window does not even close easy at all I have to jack around with the crank, he said the trim was too tight he will cut it back.