I just figured it out: This person is from India (hence no bathtubs - these are wetrooms w/ shower only and a floor drain) and since this is a corner lot hemmed in by neighboring houses, OTS = Open To Sky... ...and that massive staircase probably goes up to the roof where they have their only outdoor space as well as space for hanging laundry, etc. IMO, putting the car on the exposed corner is the worst use of space and light - I'd stash the car on another side against the neighbor's house where there's no light - locating the public rooms and the kitchen along the front of the house and the bedrooms in the back where they don't necessarily need daylight - perhaps through the use of clerestory windows into the public rooms, the light can be borrowed for the center bedroom... Either way, Inkwitch is right (if a bit abrupt) I'd get a new architect who has some talent for efficient small space design to do your home.

Hi again- I'm an Aussie and the term 'wood burner' means a metal box with a glass door on the front and in the situation where you have a 'double sided wood burner' that means two glass doors on each end. A wood burning fireplace open either side between two rooms is a different thing. Sorry about the confusion. I looked into building one of those in brick and was strongly advised to place a glass panel on one side ( as Ironwood has pointed out) the natural draughts that move through your home will take the smoke with it. A piece of glass will prevent this from happening.

A few suggestions based upon your lower photo, the fourth I guess. a. If you had the wall built, ask the guys that built it to perform your wishes. If it came with the house, call the former owner, whose name is on your deed. b. If the former suggestion is a dead end, let's analyze before we plan. You want to have a space for cooking and dining outdoors. This is such a beautiful yard, it does not deserve a portable BBQ unit exposed when not on fire, so put it in the garage as soon as it is cool. If you are going full hog for a builtin BBQ facility, perhaps it can be built against an existing wall, and just the dining area then needs the increased space. A 6' wide round table, requires about 12-14' for itself and the surrounding chairs and service area. Will you be happy with only a 15' or even a 20' section of wall moved? c. Remove the plants from the area that you plan to usurp, and about 5' beyond, and rent a sod cutter to remove all of the lawn from the vehicle entry point to the lower curved wall, by the palm, and stockpile it in shade, if possible. d. Have the contractor saw a vertical cut in the wall at the points of removal. Measure the distance of the plant bed to back wall. Cut the front bed wall that is to be removed with two sections of that overall bed dimention, so they can be placed as end walls for the two sections of bed that are no longer continuous. e. Have the contractor dig up the wall, and cut the two pieces to remain so they are free of the wall to be dumped. He will remove the existing soil from the bed. Modify any irrigation that exists, and then install the two wall slabs to their new duty locations, attach them to the remaining walls, backfill and replant as required.. f. The next step is to cultivate the compaced earth in the lawn area, rake it and resod. If the dining/BBQ areas are to be a dining terrace, you might wait until the sod is reestablished, say another month, before initiating that construction, as you don't want the sod to remain in a pile for long, or you will have to buy new. If it is to be a flagstone terrace, you can have that material delivered and stockpiled where the bed used to be, while the wall crew is just leaving. Will that fill your need. Give this post to the contractor so he can take measurements, and provide you an estimate overnight. Summer cookouts have already begun. Looks like we will miss the 4th of July bash.

Yes sure ... we did something which I believe is a club of various ideas and expertise.. Though incomplete now , I will post what we have done till now. First we have around 8 feet appox glass 12 mm between the pillars. secondly we have three boxes 27" in height with focus halogens at the bottom. Now we will decorate these boxes with glass pebbles for awesome reflective / color effect. -I do need idea on what fillers can be used which will make me buy less glass pebbles ..else i would need at least 30kg plus of these pebbles. Thirdly we will now have glass film behind these 3 tall glasses to make it quite attractive and something which will look better with or without light. The idea is to add some golden plants in the middle i.e golden leaves and branches etc. -I would like more input on what films would look great behind these pillars. Or any other idea. I will definitely post once we are done with it.