My drawing room front Window is going to be of around four feet wide. As the width of this room front wall is 10 feet out of which 3'6" will be kept for front entrance door. I am confused whether the sill height of the window should be 6 inches or 3 feet high as sofa is coming in front of it as my drawing room size is 10'0" * 14'0".

1.Remove Door and Trim If you're adjusting an existing door frame in your house, first, you will have to remove the door itself and all of the trim surrounding the frame. The door is simple enough; just pull the hinge pins out of place, tapping them from beneath with a screwdriver and mallet if necessary. For the trim, wedge a flat pry bar underneath the edge on one end of a section, and gently pull the casing away from the wall. Do the same thing for all of the pieces around the door frame and carefully set them aside to reuse later. 2.Square the Opening Off It is difficult to ensure that a door will be level and square if the rough opening is not (the rough opening is the bare bones structure before any work is done to begin a door install). So, before you begin, use a carpenter’s square to check the upper corners. This will save you time and effort later on. Remember, the more accurate your measurements, the more level your door will be. 3.Shim Door Frame Placing a pre-hung door in the rough opening will give you an idea of how it will ultimately fit. This type comes complete with a pre-made frame surrounding it, so all you need to do is carefully slide it into place and shim wherever you need around the frame to level it in the opening. Remember that wooden shims can simply be made of wedges or blocks of wood. Place a level against the door frame in your existing installation to see where you need adjustments. Then, like before, place wooden shims until it sits as it's supposed to. To keep the shims in place, nail them to the hinge. Make sure you trim any excess pieces with a saw so they sit flush with the wall. 4.Get a Level Sill Next, adjust the door sill with a flat bar or wedge until it too is level. Place the wedge or bar under the latching side of the door frame and have your help hold your door so you can check to make sure whether the top of the frame, or lintel, will need more adjustment. 5.Double Check It is important in every project to double check your work. Take the time to measure the gap between the door frame and the original rough opening. Use and nail in more wedges where necessary. If you have the extra set of hands to spare, have someone re-measure if you feel it could be adjusted differently. 6.Secure Door Frame in Opening Place your blocks of wood and/or shims into the open space over the lintel, and begin attaching the door frame to the original rough opening. Again, double check each corner to be square, before completely securing it into place. Note: Do not worry about the finishing touches just yet. You can add framing to the door after applying the paneling or drywall. Also, head and side casings will finish off a new installation nicely, covering all your small shim adjustments. Thanks & Regards, Cathrinfrancis URBELITE Bangalore

It will be my opinion don't put curtains for small doors usually windows only we can use curtains for balcony also if more than 5 feet you can try inbetween colum and in center you can try like this type of sliding doors

pls suggest me a door for 8feet height by 5 or 6 feet wide space between drawing room and veranda.will 8 by 6 dimension look odd .as iam thinking of double wooden door with half glass with transom above.but will it look good or not.