I suggest you follow the step-by-step guide for creating storage cabinets under the bathroom sink. Take proper measurements - Measure the available available space in height, width and height. Cut Plywood to size - With a circular saw and framing square, cut all the required pieces out. You can use a sliding compound saw as an alternative. Attach the base and sides - Start assembling the sink cabinets by placing the bottom piece of plywood sheet on a flat surface. Attach the back and top boards - Place the plywood sheet for the top part of the cabinet and attach wood screws to connect it to both the sides. Turn the back faces of the cabinet upwards. Keep the back piece over the structure and fix it into place with wood screws. Attach shelves - Place the cabinet in an upright position to install the shelves. Slide a shelf into the structure so it is flush against the back. Attach door - Keep both hinges of the door on the same side of the plywood sheet. Drill them using wood screws into place. Now keep the door over the cabinet structure, extend the hinges to one of the side panels and fix them to make them secure. Fix a hasp closure on the other side of the door, placing it in the center of the hinges.

Rui, On the contrary, If you look from the left it should align with the base cabinet because they are in same size. Most likely, it will go off by 3/8 of an inch after the dish washer (as it has been wiggled in). It is too small a difference to be noticed by average person because they are at different heights. We are suggesting to change either the cabinet above sink or the single box above right of dishwasher. It will be easier and the filler will be least noticeable above the sink as the shutters are already of a different size. Good news, is that you may have the cabinet boxes already. You can check by placing them starting from the left most wall whether the above suggestion works for you. Thanks, Nitin Cornerstone Designs, Bangalore.

Pawan, Please recheck the dimensions once again. 27 or 17. Frankly speaking, its not worthwhile to do a comparison in such a small project. However, teak is costlier but has many a variants, please recheck the details if it is First Quality or Burma team. Pricing is usually due to the details. Clients are often duped by initial low-ball offers. Go with one who has better client feedback.

Hello, everyone! I had my kitchen remodeled in 2018. Huge remodel, down to the studs, etc. My husband recently noticed that on one large wall cabinet, the doors had become uneven. Upon inspection, the cabinet is sagging and seems to be coming apart. I've added some photos here to show the uneven doors, what the shelves look like, what we're keeping in the cabinets, and where you can see the cabinet coming apart at the top. This is a three-door cabinet -- two doors on the right and one on the left. I'm planning to contact our contractor who installed the cabinets, but I hope to get some opinions here: Does it look like the cabinet wasn't glued properly? Did we store too much stuff in here? Was it a bad design to have such a large box to begin with? Cabinet is 53" wide, 42" high, frameless, hybrid construction. None of the other cabinets show any such problems. Thanks for any observations, information or opinions you can offer.