OK... but the wire wont be lower as it is fixed now. The wire in the pics below is the wall facing each other. They were leveled on equal height but the beam on one wall makes it seem a little above. But i think you guys are absolutely right that up and down lights wont look good there. I think you are right about down lights lessismoore. Would it look good if i go with two different lights on opposite walls??? it would look odd right.

I had purchased hafele hob 10 months back... I got it serviced 6 times... Now i requested for replacement with new one... Still they have not attended my request...

Tsilanko, I would always recommend professional installation where needed. But what I am doing here is suggesting that WHEN you are planning to build or renovate, to consider how your plans will affect you in 20 or 30 years time. Split levels are very hep when you are young. A kitchen 3 steps down at 30 is rarely a problem, but might be a hazard at 60, or, as Marjie1059 suggested, if you break a leg. ... All my parents' homes were terrible for old people. They were forced to move to a bungalow in extreme old sge because the location and design of their home was more suitable for an active young couple with a large family than for an elderly couple with stroke disabilities. I would not want to move again, so my present home has features built in that make ageing in place simpler. Mostly small changes, like grab rails, and lever handles on doors and faucets. A major disability suddenly suffered requires major changes if permanent. I did look at this because it came up in the discussion, but if you look at the heading, Planning for Disability, it means just that. Plan ahead so you don't have to make expensive changes later on. But thank you for your advice, yes, major changes are not in the DIY domain.

A good tile installer that knows what he is doing, can easily remove that single piece of tile.... carefully replace it with another one. Do you have another extra pieces of the same tile? Do you know what brand and color the existing grout is? That will be more of the issue trying to get the grout match to match up or the finding the same tile (in the same dye lot) if you need to buy another tile. Did the heat cause the break or did a pan bang into the glass? Consider installing a heat resistant Lumicor or 3 Form panel behind the stove. Any flat material that can be sandwiched between two resin panels. 1). Crushed glass. 2). Fabric. 3). Fabric. 4). Fabric.